Fixed relative references
This commit is contained in:
parent
224698bc94
commit
697b529fa2
@ -4,9 +4,9 @@
|
||||
|
||||
___
|
||||
|
||||
1. [Preparing transparencies (KiCad)](electronics/pcbfabrication/transparencies)
|
||||
1. [Applying and exposing the photoresist dry film](electronics/pcbfabrication/applyphotoresist)
|
||||
1. [Etching the board](electronics/pcbfabrication/etching)
|
||||
1. [Removing the photoresist film](electronics/pcbfabrication/removephotoresist)
|
||||
1. [Applying and exposing a solder mask](electronics/pcbfabrication/soldermask) (optional)
|
||||
1. [Drilling through-hole components using a CNC machine](electronics/pcbfabrication/drilling) (optional)
|
||||
1. [Preparing transparencies (KiCad)](pcbfabrication/transparencies)
|
||||
1. [Applying and exposing the photoresist dry film](pcbfabrication/applyphotoresist)
|
||||
1. [Etching the board](pcbfabrication/etching)
|
||||
1. [Removing the photoresist film](pcbfabrication/removephotoresist)
|
||||
1. [Applying and exposing a solder mask](pcbfabrication/soldermask) (optional)
|
||||
1. [Drilling through-hole components using a CNC machine](pcbfabrication/drilling) (optional)
|
@ -6,7 +6,7 @@ ___
|
||||
|
||||
**Prerequisites**
|
||||
|
||||
* [Copper layer printed on a transparency](/electronics/electronics/pcbfabrication/transparencies)
|
||||
* [Copper layer printed on a transparency](transparencies)
|
||||
* [Laminator](/electronics/bom#hardware_laminator)
|
||||
* [Circuit board](/electronics/bom#consumables_circuit-board)
|
||||
* [Photosensitive film](/electronics/bom#consumables_photosensitive-film)
|
||||
@ -61,6 +61,6 @@ Check your board under a microscope. Anywhere there is bare copper will be etche
|
||||
It is not uncommon to find bits of undissolved film remaining. You can do small corrections with a knife. If there is too much film to cut away, you could try putting it back in the developer a bit longer. If that doesn't help, or if the film has become loose in places where you don't want it to, it's probably best to start over. The good news is that this is relatively easy to do at this point:
|
||||
|
||||
1. Skip the etching step for now
|
||||
1. [Remove the photoresist film](/electronics/electronics/pcbfabrication/removephotoresist)
|
||||
1. [Remove the photoresist film](removephotoresist)
|
||||
1. Tweak any settings (exposure time and/or intensity) if necessary
|
||||
1. Start over by cleaning the board and applying new film
|
@ -6,7 +6,7 @@ ___
|
||||
|
||||
**Prerequisites**
|
||||
|
||||
* [Copper board with photoresist applied](/electronics/electronics/pcbfabrication/applyphotoresist)
|
||||
* [Copper board with photoresist applied](applyphotoresist)
|
||||
* [Ferric chloride](/electronics/bom#chemicals_ferric-chloride)
|
||||
* Sponge or brush
|
||||
* Gloves
|
||||
|
Loading…
Reference in New Issue
Block a user